Ford F-150 can perform as work vans while handling as well as most passenger vehicles. The sway bar is partially answerable for this. sway bars minimize physique roll when maneuvering by stabilizing the truck physique and chassis. The sway bars mount to the entrance body after which hook up with the wheel hubs at the ends by way of sway bar links. A clunk noise in the entrance end or elevated body roll when cornering is indicative of a worn sway bar. Inspect the bar’s ends the place the links bolt to the bar and substitute the bar when you note deformation of the ends.
Ford F-150 Sway Bars Installation Procedures
1. Brace the left rear wheel with two wheel chocks to prevent the F150 from rolling. Carry the front end with a floor jack.
2. Place a jack stand below both sides of the front body, behind the sway bar brackets. Decrease the F150 onto the jack stands with the ground jack.
3. Unbolt each ends of the sway bar from the sway bar hyperlinks utilizing a socket set. Take away the front bolts in the sway bar brackets using the socket set.
4. Loosen the rear sway bar bracket bolts sufficient to permit you to slip the sway bar out of the brackets on the front facet, where you eliminated the entrance bolts. Set the sway bar aside.
5. Slide the brand new sway bars into the sway bar brackets, making sure not to displace the sway bar bracket bushings. Substitute the sway bar bushings if they show indicators of excessive put on, such as cracking or deformation.
6. Bolt the ends of the sway bars to the sway bar links in reverse of the way you unbolted the hyperlinks from the outdated sway bar.
7. Set up the front sway bar bracket bolts with the socket set. Tighten the rear sway bars bracket bolts with the socket set.
8. Lift the F150 with the ground jack and remove the jack stands. Lower the truck with the ground jack. Remove the wheel chocks from the back tire.